The well-known Japanese web site Macotakara is made of the so-called 3D printed model of another iPhone we will see in 2020. Judging by its appearance, we can deal with the return of the edges of the apartment we saw earlier with the iPhone 4 and iPhone 4s. Proceedings of the project have been posted in IP Pro for 2018 and where other rumors are also pointing.
Macotakara is a website that many times over has advanced features of future Apple products. Of course, the publication shows that this 3D printed model comes from a source in Alibaba. So we have to take your information with a consistent dose of skepticism.
New design for 2020 iPhone
Both the video and the photos provided by the Japanese media reveal several details. They all revolve around the size and physical appearance of the signal, which compatible with the current iPhone 11 Pro Max successor. Its screen, therefore, corresponds to 6.5 inches though some rumors set it larger, reaching 6.7 inches.
This may be thanks to the reduced frames, though not specific to the model (Macotakara attached the attachment to the Current Home). In to compare with size the largest model of 2019, the modes may look like this:
- Height: 159mm vs 158mm on iPhone 11 Pro Max.
- Width: 78mm vs 77.8mm.
- Thickness: 7.1mm vs 8.1mm.
The size is busy as it will be reduced by 1mm, though it is unclear what the print has taken for the camera size or not. It's hard to believe that Apple decide to lose your devices too much, with a noticeable impact on the independence you will be involved.
But the most exciting thing is to see how this model shows a straight-sided iPhone. It's a design that was to be achieved as the iPad Pro 2018, which we first saw on the 2010 iPhone 4. more or less design up to the current generation, so they are likely to indicate the emergence of the next generation of iPhone.
Smart forum is back
There are some additional changes to the design of this model. As a comparison, the buttons on the left side were slightly reduced in relation to your position today. The right side also sees the lock button and SIM card slot down.
In addition to these changes, you can see the reminder of the iPad Pro charging Apple's pencil. Apparently, the Apple Pencil 2 measures 166mm, about 10mm above the signal, so it would not suit him. A new model will be needed for the iPhone 12, which would also need to be smaller than the current 8.9mm.
It's not the first time you've seen rumors about an Apple Pencil compatible with the iPhone. We have several generations with previous rumors that put the stylus as an accessory for Apple to keep, or they have never risen.
Via | 9to5Mac.
