Adaptive Synchronization or also called Adaptive Sync or VRR as far as possible, there is an increasing number of gaming monitors on the market. Although it may seem obvious, many users think that when they buy a new track with a technology like FreeSync, this technology will automatically work as soon as they connect to their new screen. But in the majority of cases it is not, so today we will teach you how to work AMD FreeSync or FreeSync 2 With your GPU and monitoring.
Before we begin, we must keep two things in mind, which though they may seem obvious, are worth emphasizing. We must not only be vigilant (or TV) with such technology, but an AMD graphics card from Radeon HD 7000 series, launched in 2012, with all of the following Radeon image products.
As for the APU, AMD says that everything is consistent from those presented under construction Ryzen, where the motherboard should have a hole DisplayPort or HDMI at least
So we can work on FreeSync or FreeSync 2
For this to happen, graphics card drivers must be included, in this case Adrenalin, which are important as they correct mistakes and add to the improvement. If we do not have them renewed it is best to do so.
There are two ways to enter to stop this driver, where it has worked, but before doing that and it follows ((there are more than 900 types) at the moment, we have to make sure that within the control of the monitor itself (OSD) we have the following symptoms:
- FreeSync is enabled.
- It's an anti-blur (own) it is disabled.
- Showing set to 1.2 or more
- Connect monitoring and GPU using cable DP 1.2 or higher.
If we meet these requirements we will go to the software part through the driver. As we say, once the PC is installed and started, when we return to Windows we will have two basic options for installing the configuration panel.
Pressing the right mouse button on the desktop will appear in the selection window, where we see the "Radeon Settings" option. The second option works just like this, it's simply another way to install a configuration panel.
Below, near Windows time and in the taskbar, we will see a red icon. We will only have to double click and that the control panel will open.
At this center we have to go to a specific category such as «Screen«.
We will click on this section and we will open the basic options to configure our gaming monitor.
By default, as long as we haven't installed the driver after a new alert, the FreeSync class will be activated, as shown in the picture.
We just have to click and the driver will mark it active:
We must not do anything else, or use, or accept anything, as simple as that, so once this process is completed we can close the Radeon configuration and enjoy the beauty of this technology by AMD.
The post How to Work for FreeSync or FreeSync 2 with an AMD graphics card appeared for the first time on HardZone.
