If you want to be proud of the internal hardware on your PC that is nice, clean and tidy, the power supply cables are basic, and more if you do it (at least in part) modding. However, these threads are very long and almost impossible to fit and present properly, right? Well, it's actually not that complicated when using "combs" with these strings, and we'll show you next.
String weights will help you to be perfect
They are called "knit threads" because these combs are used, his name in English (should you want it) is "Caf combs", and they are almost obligatory if you use sleeves to give your power a good look Even though most web-based cord assemblies you can buy already include some of these scans , they are usually inadequate for all cables and you will have to purchase additional units.
The bad part is that it's not as expensive as it may cost, but it certainly represents something that will help improve the beauty of your PC's interior.
How to tie the wires
This process is a little short but not unifying at all: we will just produce one of these scissors (we will have to choose one at the right size as it makes sense. In other words, the ATX 24 cable will have to use that camp) It has 24 holes, 12 for each face) of two rows of wires, and we will introduce each cable to each hole in order so that everything is the same.
Very good go present these pages a few centimeters (Approximately 8-12 cm) throughout the length of the cable, as it is the only way to ensure that the cables will fit.
Doing this has its advantages and disadvantages: the advantage is that we will guarantee that they stay the same and look good, but the bad thing is that we will provide cable a high durability, so even though we can bend the cable without any problems, we may have to extend the distance between the combs to areas where we have to bend to load them into the box.
The little knit-knitting technique makes them look even better enter the camp and “drag” it towards the storage area and they will dwell there. This way we will (integrate literally) make the straps easier and look better in the end. However, keep in mind that the negative area of the sleeve cables will not always allow us to do this, especially on wires with multiple connectors such as the 24-pin ATX, and in that case it can be difficult to move the camp once installed.
When we assemble and move the source of the sleeve cables correctly, there will finally be a clean, neat and comfortable interior.
