Before you begin, you should remember that the process of cutting off PC debt grids will depend on the product, since cutting PVC is not the same as steel, without moving on. So, depending on the content you will need some tools or others.
Prerequisites
What we would recommend here are the tools and tools that you will need for the "normal" conditions you will face when cutting the PC case radiation, but as we mentioned earlier, it will depend on the materials you are made of and where you should pay attention to what your needs are. That being said, here are some materials you will need:
- Dremel with its own set of accessories (this is the best choice for any grille).
- Coarse grain sandpaper (800-600) and middle (400).
- Cutting pipes.
- Bodybuilder tape.
- Honey, set a square, a reference and a mark (odd mark).
- Drill + saw (if the grid is plastic, though Dremel can be used for this if you have the necessary accessories).
How to cut a grid
The first step is to distribute a piece that you will cut to work with it comfortably. It is important to tag with bodybuilder tape wherever the grid is, as this way we can mark exactly where we want to cut.
Now, with the square, bevel and ruler we have to measure and mark the inaccessible marker where we want to cut the grid. Take your time to do it right, because the mistake here may be that in the long run you cut where it is not. The recommendation here is not to cut the grid, but to leave a millimeter to save – that is, to cut an extra millimeter – so that the cut is regular.
Once you mark where you want to cut the grids, and you are sure of it – we repeat that there is no turning back when you start cutting – continue cutting. With this step, and depending on your expertise and materials, you can use the Dremel cutting tool, or you can drill a hole through the hole to allow the jigsaw to penetrate. In your opinion.
So far it's not that we've found America, right? Measure, mark and cut, no mystery. But the key to making everything perfect is the following steps (well, with the previous advice to leave 1 mm on each side for everything to fit properly), which is basically sanding.
We recommend that with the Dremel itself and use the right sand add-on for your box, you can easily make the whole sand on the cut to bend it ». Then write it first with a molded water carpet (measure it in water, of course) and give it to the last one with a neat writing pad. That is the secret of complete eradication.
