In a few cases when we are going to buy a dust filter we are looking at size and price instead of the type of material used for that purpose.
Different types of dust filters
The fact is that the filter material is as important as the frame or the price, because if this doesn't fit with the fan to go behind or the internal air flow of the cheese, we may be creating resistance that makes it difficult to operate.
Therefore, we will know the the primary filter material of dust market
Nylon / Polyester
They are the most widely used, widely used products in high quality products Demciflex, because they have their biggest benefits flexibility and be able to produce them with fine mesh. They are usually characterized by attaching a solid frame or bottom, either plastic ABS or variable, so it has an added cost.
This is not an obstacle we can find the magnetIn contrast, flexibility is a factor that allows manufacturers to select this type of material for their magnetic products.
Nylon or polyester are highly recommended dust filters Because they are large enough in their radiation, but are not very limited in air travel, therefore, most chassis manufacturers use these filters for their own purposes.
Metal
The durability of these types of metal dust filters gives them some interesting advantages to other models: they can be obtained there are no frames, leaving the metal mesh as the filter itself has corresponding holes.
This gives them a bit of stiffness, which they need for a particular chassis. We can find other versions that have this feature also with metal frames, which can add more resistance to the set and allow the mesh to take on more unusual shapes to improve airflow.
They are shown when we have fans with low tuli pressure, because they will suck a little air into the front of the filter. The formation and distribution of the mesh are common small size, which allows for more air to pass through, but will not store smaller and smaller particles.
Cotton
Frequently made of materials such as the smoke detectors that we see most commonly in major Asian cities, these filters have a trick that is, as a rule, electrostatic. So also knowing this, we have to consider that they are very dense, which is only shown by the most dusty places, dust, line, tobacco or environmental pollution.
Plus, our fans should be very high tuli pressure, so that they can take out the air or chase the air out of the chassis, depending on the type of pressure, either negative or positive.
At the moment they are not working because they mean the highest spending of fans, and they also greatly increase the sound produced by the fans. It can be found along lines for other purposes, where the probability is the same.
Foam filter filters
It is another widely used option for some manufacturers, where its lack of durability, in general, is to use it with double layer, add the size and complexity of air resistance. It's already on its own, noticeable, or even in color, rather than giving a system like a beehive panel covered with layers.
This is fine for pulling the dust even in its smallest book, but at the same time limited, adding to the double frame as the general rule creates a higher limit. It should be noted that it is not as hard as cotton, but it is not too far away.
Like cotton, it can be found on the rolls cut as we want, like the one offered by the product Calm down. By not limiting cotton, we can compensate middle-class fans with tuli pressure, on the other hand ensuring that, and in contrast, noise does not increase, but can reduce (a low-flow coast).
Table of Contents
